* Go to the end of the line and type 'single' as a separate word (press the and then type single). * Select the line that starts with 'kernel' and type 'e' to edit the line. * Select the kernel that you wish to boot and type 'e' for edit. * Open a console terminal session with the M/MX appliance. Use Putty, Hyper terminal wont work with this procedure. Localhost.localdomain(config)#ip pim enable Localhost.localdomain(config)#interface eth1 Localhost.localdomain(config-if)#ip pim sparse-mode Localhost.localdomain(config)#interface eth0 Lets enable multicast routing with sparse router config This will need a license of “Advanced Routing Blade” To enable Secure Platform Router Config mode type “pro enable” # tcpdump ip multicast will show you multicast packets. If you just want to let that traffic pass through the gateway and the gateway does not need to perform any dynamic routing decisions then there is no need to enable Splat Pro. Regarding sk31190 Secure platform pro needs to be enabled if you would like the gateway to participate in the multicasting traffic. In order to allow multicast traffic by the gateway, you need to follow sk35996, In addition you also need to create an allow rule with the service “pim”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |